Model Train Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. Technical Model Train Forum
    Hello! I have heard a bunch of info about some HO layouts being operated wirelessly by phone and through a Wi-Fi server router with a PC connected to it. I have heard somethings as Raspberry Pi would do the trick, but it only works within a certain range as far as I know. I want to have...
  2. DCC Forum (Digital Command Control)
    Hello, my club has an NCE Procab dcc system using a pb105 and cs02 but no matter what I do the light slowly flashes indicating a short. I disconnected everything and started over using the wiring diagram, but it still shows a short. The last thing I tried was disconnecting the track leads but...
  3. DCC Forum (Digital Command Control)
    Hello I use the NCE Power Cab to read the decoder information of the locos. However, when reading it, it only shows the following parameters: Manufacturer: 11; Version: 255 (examp). So where can I look up these values for more information about decode ? Thanks
  4. DCC Forum (Digital Command Control)
    Hello I'm currently using a Prodigy Advance MRC controller (used and bought from Ebay 2 years ago). It is having some problems now and I want to replace it with a new NCE Power Cab controller (2Amp type used to run 4 HO loco or 8 N loco at the same time). In your opinion, should I buy the same...
  5. HO Scale
    Sorry if this has come up before but I am fairly new to DCC and am looking to add a decoder to an Atlas Silver GP40 that is DCC ready. It's one of their new ones and has an 8 pin plug in it. My question is about the dummy board as they describe it. Does that need to be removed or can it stay? I...
  6. DCC Forum (Digital Command Control)
    Hello, I recently got an NCE Procab, but it didn't come with anything but the handheld. I'd like to use it on my layout without buying a Powercab so I think I may have found a solution. 1. NCE Powercab connection panel 2. NCE Powercab connection panel power supply 3. Track power connector from...
  7. N Scale
    Hi everyone I have NCE Switch-Kat decoder but cannot program it (using MRC PRODIGY EXPRESS) Any advice?
1-7 of 7 Results
Top