Model Train Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. HO Scale
    Hello all! I have 2 Z1000 transformers and have a few issues. A) They run hot, they immediately burned out a board in my Broadway Limited #1219 and then the replacement board. B) Bell and whistle work fine, for trains equip for it but the reverse direction button does not work at all and on...
  2. O Scale
    I have a small video of the problem I am having. I have a short somewhere on these two switches causing a spark on the caboose and engine whenever they travel over the switch in the "switched inside" position. There are no sparks whatsoever when the train is traveling in the oval direction...
  3. HO Scale
    Alright I'm pretty new at this hobby and I just finished wiring up my table. I did block wiring with single cab and 8 blocks. I did a lot of research before I attempted to even start doing anything wire related. I just tried running a train around the track for the first time earlier today...
  4. HO Scale
    So I just layed some EZ track around my dinner table and for some reason, my Bachmann onboard GS 4-8-4 loses all power near the end of the first curve (22" radius). The loops isn't even that long either. Suggestions? Thanks!
  5. O Scale
    Hey guys, I am brand new on here, and to model trains. I recently acquired a 1964 Lionel 6 Unit Ready To Run train set #11450 from my girlfriends family. I would like to restore it and get it running again but I am unaware of how much that would deplete the value of the set. I had ran it for a...
  6. O Scale
    I've got 2 - 1122 and 2-1122 E switches. Haven't been used since 1950's. Plunger will not come out in one so I think it is toast. I'm re-wiring the switch lever boxes. After hooking them back up according to how the wire goes on the switch, they still fail to move the switch. Makes some...
1-6 of 6 Results