Joined
·
12,471 Posts
The building started on this thread. I wanted to show it off before I shipped it out. The chimneys were the challenge I made six. Then I had to use a larger one since one hole was cut too large.
When I do sheet metal with everbend you need to add a correction or trim the piece square. With all the little annoyances the piece came out just fine, sometimes I surprize myself. So Jim it's all ready to paint. It will come apart but remember the chimneys only go in, one hole one way.
![]()
![]()
When I do sheet metal with everbend you need to add a correction or trim the piece square. With all the little annoyances the piece came out just fine, sometimes I surprize myself. So Jim it's all ready to paint. It will come apart but remember the chimneys only go in, one hole one way.
, and deepest gratitude. 
