Model Train Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
707 Posts
Discussion Starter #1
Finally getting back my 316 last September i replaceed wires fingers and speaker. could not get it to run right for 3 weeks i would take it apart put it back etc etc . so i sent it to doug peck at portline . tomorrow it will be home.
 

·
Registered
Joined
·
5,602 Posts
Glad your 316 is home. About those speakers, I try to keep my steamers as original
as possible. Except for those speakers. I remove them. I keep them and the other stuff that goes with the speaker and the next owner can have them. They are always in the way
when I install a new harness and I think they sound terrible. Just my opinion. Good luck with yours.
 

·
Registered
Joined
·
1,399 Posts
I'm curious as to what actually was wrong that you couldn't get it running. Keep us posted and let us know what was wrong if possible.
 

·
Registered
Joined
·
707 Posts
Discussion Starter #7
No photo had to send it back engine not sitting on track right sparking really bad tender rocks back and forth and tow bar come out of tender.
 
1 - 7 of 7 Posts
Top