Model Train Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Anyone know how I can fix this? It came off in a derailment a couple days ago
560615
940D1A40-8B2E-483C-BAD9-BCBF4045D4F0.jpeg
 

·
Registered
Joined
·
5,505 Posts
Carefully slip it back in place, then, using a fine brush, apply liquid styrene cement to each of the top points...very...carefully. Capillary action should take care of it.
 

·
Registered
Joined
·
10,743 Posts
Since it didn't break, it was probably just sitting there in the "tracks" inside the car. Since it came out, it will probably go in just as easily. As Shay suggested, a few drops of styrene cement, applied with a brush or needle applicator will keep it in place. Do the other two while you're in there.
 
1 - 3 of 3 Posts
Top