Model Train Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
5,736 Posts
Not for me buddy. I have never had a problem using a wheel-puller, and if I did, I would use the old 2 screw-driver deal,lol.
 

·
Registered
Joined
·
1,588 Posts
Discussion Starter #5
That tool is very similar to using 2 screwdrivers. Just get a puller Broke.
I made a wheel puller out of a gear puller in where I ground down the 1/4" shaft to a point. It works OK but for some reason I am not happy with it . At any rate, I am not going to tear down any more boilers anymore. I have 10 boilers with two in a perpetual state of being apart.:laugh::laugh::laugh: Sooner or later, I will get them together.
 
1 - 5 of 5 Posts
Top