Model Train Forum banner
1 - 1 of 1 Posts

· Registered
8 Posts
Discussion Starter · #1 ·
I have a Athern 45-2 engine ,and i am using Lentz DCC system and i cannot get this engine to crawl real slow like the outher atlas engines that i have, i have to set it on the second speed notch to get it to start moving and then it starts kind of fast, i have tried to change the voltage and speed settings in the CV, aney sugestions HELP


1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.