Model Train Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
I was using JMRI to change speed cv's on an Atlas SD60 n scale, and after i programed the changes on my program track and placed the engine on the main it would not run. No lighjts etc. I tried using F8, but to no avail. Any suggestions as to how to remedy, as well as what I may have done to create this issue would be appreciated. Thanks.
 

·
Registered
Joined
·
727 Posts
The first thing I'd try is...

Reset CV #8 to "8".
(reset the decoder)

This resets the entire decoder to default specs.
Then... you start over.
 
1 - 2 of 2 Posts
Top