Bachmann E-Z Command DCC SPeed Control

3153 Views 3 Replies 4 Participants Last post by [email protected], Jan 3, 2008

attaboydj

Discussion Starter · Dec 25, 2007

For anyone who has tried the Bachmann E-Z Command DCC system, what is the secret to get the engines to run at less than full speed. My controller has a large deadband inthe throttle, and both engines supplies with the train set run the same way, all out.

Please advise if you have any clue.
Regards,
Attaboydj

Save

1 - 1 of 4 Posts

tworail

· #2 · Dec 28, 2007

Thats odd, as the behaviour you are describing would fit running analog locos on a DCC equipped layout, they will run at the supplied track voltage (which is usually as much as possible with DCC systems)

Any help from the manual?

Save

1 - 1 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.