Model Train Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
62 Posts
Discussion Starter #1
There is an LED just below the Speed Button on my CAB-2 controller. Sometimes when I'm operating it will blink a couple of times, then stay off. This seems to happen at random intervals and I cannot see that it is directly related to anything I'm doing with the controller.

I read the manual this morning, and didn't see anything about this LED flashing during normal operation.

Any thoughts on what might be happening?
 

·
Registered
Joined
·
159 Posts
The red light indicates the Cab2 had a communication issue with the base. It's usually not an problem unless it happens often or stays on. Every now and again isn't going to matter.
 

·
Registered
Joined
·
517 Posts
The red light indicates the Cab2 had a communication issue with the base. It's usually not an problem unless it happens often or stays on. Every now and again isn't going to matter.
I thought it meant that a signal was sent to the base every time the operator makes an input.
 
1 - 5 of 5 Posts
Top