Model Train Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
62 Posts
Discussion Starter #1
I picked up a locomotive at the train show in Hamburg New York unfortunately it is addressed I believe at 3000 and I can't change the address to work on my system with the Bachmann EZ controller. Does anybody know how to reset the address without going out and buying a new controller unit so I can re address the locomotive?
 

·
Registered
Joined
·
8,459 Posts
I found this information thru Google.

https://www.reddit.com/r/modeltrains/comments/5aukwt/how_do_i_reset_a_bli_dcc_locomotive_on_a_bachmann/

Scroll down a bit and you'll see the instructions.

Apparently, you take the loco OFF THE TRACK, before
proceeding with the regular address change routine.

As I read it, you press and hold any address as you also
press the STOP button. Then put the loco back on
the track as you press the 'new' address button.
The loco should jerk in acknowledgement. Then
press stop again. The loco will now have the new 2 digit
address.

Don
 
1 - 3 of 3 Posts
Top