Model Train Forum banner

Drive Shaft

3837 Views 3 Replies 3 Participants Last post by  rhfun
I bought an HO 4-4-0 Western and Atlantic, I think General around 1968..
The plastic drive shaft broke and I have no idea how to get a new one.
I can not recall who the exact manuf was, but on the bottom it does say
Pocher, Italy. Missing front plate as well. Any ideas where I can
buy such a replacement? It had a 6 side design in the tender and a
round end in the engine part. Thanks !
1 - 1 of 4 Posts
Welcome...these guys would likely have it..

Pocher was sold under the AHM umbrella for awhile and most of that stuff fits from one to another.
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.