Model Train Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
331 Posts
I don't have any intermountain dcc,but I do have bli.I have had the same issue a time or two with my bli stuff. check the instructions and see if there is a reset button.there is on my bli locomotives
 

·
Registered
Joined
·
36 Posts
Discussion Starter #4
so the issue was that somehow the motor plug into the board just became loose. At the same time, the train also had some DCC setting reset that allowed it to run on DC track. the parameter CV29 needed to be set to 38, which it was just nothing.
The extended address table is shown here with more codes and stuff:
address table extended
 
1 - 5 of 5 Posts
Top