NCE coiled cable
1 - 5 of 5 Posts
Joined
·
761 Posts
Amazon.com: NCE CORPORATION NCE5240209 RJ12 Connectors 4-Wire Coiled Cable for Cab Bus, 7-Foot: Toys & Games
Buy NCE CORPORATION NCE5240209 RJ12 Connectors 4-Wire Coiled Cable for Cab Bus, 7-Foot: Cable Locks - Amazon.com ✓ FREE DELIVERY possible on eligible purchases
www.amazon.com
Joined
·
2,138 Posts
I have the Powercab and an NCE-06 remote. Nothing fancy as this is enough to run my layout. I am just looking for a neater cable for my layout. The flat one is always dragging on the floor etc. Especially when I am sitting right by the jack. The coiled would be perfect.
1 - 5 of 5 Posts
Join the discussion
Recommended Reading
-
Decoder install problem with Overland Gas Turbine
DCC Forum (Digital Command Control)I've installed a Digitrax DZ143 in an Overland Models Gas Turbine locomotive, and am having issues. When I put it on the programming track I can read and write CVs, but when on the test track I get nothing, no lights, no movement. Is it safe to assume that since I can read and write to it that...- 3
- 71
-
SD40Tom · updated
-
New to DCC - Trying to Configure Train Lighting (Some bulbs not working correctly)
DCC Forum (Digital Command Control)Hello Everyone, I finally made the jump to DCC this evening. Though I'm facing a few issues, watching multiple trains just sit on the layout waiting, with lights on and not moving is awesome. Better yet, bright lights without having to put the train into "back to the future" mode is great! I'm...- 12
- 163
-
Pendulum_Station · updated
-
Run Small Chip LED’s Off Of Decoder
DCC Forum (Digital Command Control)Hello, I am using a Digitrax DN166PS Decoder for my scratch built locomotive. I bought some LED’s from a website called evandesigns.com. Each LED came with a resistor leading into a large rectifier with a capacitor connected to its output in parallel with the LED. All of these components take up...- 13
- 207
-
BLI Heavy Mikado CV changes.
DCC Forum (Digital Command Control)Recently bought this engine and after breaking it in and making some track adjustments I wanted to add the start and stop whistle signal by adjusting CV227 to 6 from value 2 which is no signal. I used my NCE Powercab on the programming track and the result was that the engine went completely...- 4
- 66
-
NCE USB wiring
DCC Forum (Digital Command Control)I am attempting to hook up this USB. I'm not sure it is working. Going by the wiring diagram. It shows a 12V supply has to be used at the panel. I will assume the "track" wire coming in/out of the left rear port is the wire going back to the Power Pro box. The left front port to the Power Cab...- 10
- 146
Join now to ask and comment!