Model Train Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
5,454 Posts
Always good to test an extra figure before attempting modifications on the figure of need ...

I suspect the plastics used for figures will soften circa 250+ deg. F. There's many Youtube videos softening PVC pipe to change it's shape using a heat gun (for shrink wrap). I used my gal's hair dryer to soften a 1" PVC pipe to shape. It took several minutes to heat it up but worked great. I even had a piece begin to discolor (burn) from leaving the hair dryer on it too long at too close a range.
 
1 - 1 of 1 Posts
Top