Model Train Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
441 Posts
Styrene is VERY printable for signshops, you might be able to find a sign shop with a flatbed printer who could print onto say .030 styrene. Your only issue might be getting a good scan resolution out of an old magazine. The magazines were rarely printed at high resolution.

Craig
 

·
Registered
Joined
·
441 Posts
Another thought, use the styrene and spray adhesive to glue down paper printed stencils. If you spray the back of the paper, a product like 3M 77 spray is formulated to stay on the original sprayed surface when removed.

With the stencil stuck on you can then use your good old Xacto to make the various cuts. Then peel the paper back off.

Craig
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top