Model Train Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I have a Lenz Gold+ decoder I recently put in a HO Bachmann S4 diesel.
The problem is the motor won't shut down completely on no throttle and keeps turning, albeit very slowly. I've done a reset and has made no difference. Any ideas? Or could it be a problem with the motor?
Any suggestions gratefully received.
 

·
Registered
German, Swiss, and Austrian outline. HO/HOm
Joined
·
6,566 Posts
Check CV 02 that controls starting voltage on the Lenz decoder and make certain your controller is at speed step zero.

Keep lowering the voltage a small amount at a time on CV 02 until the locomotive stops moving. This is a trial and error procedure as there is no hard setting for this. Each locomotive motor will be different.

If CV 02 is already at zero I'm out of ideas.
 
1 - 4 of 4 Posts
Top