Model Train Forum banner
1 - 4 of 4 Posts

· Registered
935 Posts
Discussion Starter · #1 · (Edited)
t man, i want to know first off, and this will be clear so read careful. can i put a resister inline of the hot wire that goes to the brush plate on a ac loco to slow the motor down. if so, what amp and omhz?

secondly, can i do the same on a ac/dc loco. for example the 80s+ lionel ac locos have a ac/dc converter board and run on a dc can motor. can i put a resistor on one of the wires going to the motor to slow the motor down?
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.