Model Train Forum banner

turnout wires cut

1556 Views 2 Replies 2 Participants Last post by  rutlandville
I acquires several turnouts with all three of the wires cut off at the housing for the switch. I have plenty of wire. is this an easy fix with a fine point soldering iron? I would much rather use remote switching rather than manual but I don't want to buy new if these can be fixed!
1 - 1 of 3 Posts
There is no reason that you can not fix these, as long as you can find a fine enough soldering tip for N scale :)

Just make sure that you get the wires in the right order when you hook them up to the switch and remote; I know it seems that everytime I hook up a switch I get the wires in reverse order because I do not look at the directions, ugh :eek:
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.