Model Train Forum banner

turnout wires cut

1555 Views 2 Replies 2 Participants Last post by  rutlandville
I acquires several turnouts with all three of the wires cut off at the housing for the switch. I have plenty of wire. is this an easy fix with a fine point soldering iron? I would much rather use remote switching rather than manual but I don't want to buy new if these can be fixed!
1 - 2 of 3 Posts
just what i wanted to here. i hope finding the soldering tip isnt a problem
1 - 2 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.