Model Train Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
321 Posts
Discussion Starter #1
Any problem wiring two machines to one switch? I have a few cross over sections and would prefer one switch to position for crossings. Using Atlas custom line turnouts and mighty mite machines with Atlas controls.

Sent from my Moto Z (2) using Tapatalk
 

·
Registered
Joined
·
3,243 Posts
None at all. That's how cross-overs are wired so both points operate together. It wouldn't bode well if only one point was thrown for a crossover and a train was approaching to change tracks.
 
1 - 2 of 2 Posts
Top