Model Train Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
Hi

I want to modify a Bandai shorty lcoo with DCC + stayalive. So it needs to be small.

Can anyone tell me if a Zimo MX600 has pads to solder a stayalive to? In the manual, it there is an eaxample of this with an MX623 but I can't tell if the PCB layout is comparable on the MX600.

Or can anyone recommend a better decoder for the task that isn't too expensive?

Secondly can anyone recommend a stayalive unit? I'm looking at a TCS KA1

Thanks!
 
1 - 1 of 1 Posts
Top