What is there I can do for my older train engines that won't run down the tack? The light comes on but won't roll & when I put another one on the track you can tell it labors from the draw on the one that doesn't roll/run but the light is on? Any suggestions? Thank you for any & all replies guys!!
Shawn Wallace
It would help if you were to post a photo of the engine and especially the undersides. If you can photograph the insides (without the shell), it would definitely be helpful.
There can be a number of reasons your
locos won't run...but we need to know
what scale and, if possible, the make and
model. Pics also are a big help.
Most likely they are fixable...probably
are in bad need of cleaning.
But, have no fear, we can get them
running with you doing the work, of course.
Don
locos won't run...but we need to know
what scale and, if possible, the make and
model. Pics also are a big help.
Most likely they are fixable...probably
are in bad need of cleaning.
But, have no fear, we can get them
running with you doing the work, of course.
Don
The wheels pick up power so they need to be cleaned well. Isopropyl alcohol on a Qtip usually works. Gears can also be cleaned this way and lightly oiled with a plastic friendly oil such as Labelles. Make sure there’s no debris stuck between the gears and the case.
We have a few members who run a lot of Tyco.
They may have some specific suggestions for these. Also, clean your track. Do not use steel wool for any of this.
We have a few members who run a lot of Tyco.
They may have some specific suggestions for these. Also, clean your track. Do not use steel wool for any of this.
That is known as a Power Torque motor. There are between 1 and three screws which hold the trucks in. Once you remove the trucks, you can remove and clean all the other gears. Take a look at this link:
Tyco Depot Power Torque Maintenance thread
Tyco Depot Power Torque Maintenance thread
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
